1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
|
// WSUG Chapter Four
[[Chap04]]
== Troubleshooting with Wireshark
=== An approach to troubleshooting with Wireshark
Wireshark is a very useful tool for network troubleshooting, since it contains a
number of features that allow you to quickly focus on problems in your network
for several reasons:
* It allows you to focus in on specific packets and protocols, as you can see a
large amount of detail associated with various protocols.
* It supports a large number of protocols, and the list of protocols supported
is growing as more people contribute dissectors
* By giving you a visual view of traffic in parts of your network, and providing
tools to filter and colorize that information, you can get a better feel for
your network traffic, and can understand your network better.
The following general approach is suggested:
* Determine that the problem looks like a networking problem. There is no point
in capturing packets if the problem is not networking related.
* Figure out where to capture packets. You will have to capture packets from a
part of the network where you can actually get network traffic related to the
problem. This is especially important in the presence of switches and routers.
See <<Ch04ROUSWI>> for more details.
+
Because Wireshark can read many capture file formats, you can capture using any
convenient tool. One useful approach is to use _tcpdump_ to capture on remote
systems and then copy the capture file to your system for later analysis. For
more details on capturing with _tcpdump_, see <<Ch05tcpdump>>.
* Once you have captured packets that you think relate to the problem, load them
into Wireshark and look for your problem. Using Wireshark’s filtering and
colorization capabilities, you can quickly narrow down the capture to the area
of interest.
* Examine the appropriate fields within the packets where the problem appears to
be. These can often help to reveal the problem.
[[Ch04ROUSWI]]
=== Capturing in the presence of switches and routers
In the old days of Ethernet, all network traffic was spread over one “yellow”
cable through the whole network. Capturing data was easy, as all packets from
the network could be captured using the “promiscuous mode” at any place in the
network. The only devices blocking network traffic, were routers. But as routers
were extremely expensive, they were not widely used.
Then Ethernet wiring using hubs become the state of the art. As the hubs still
spaded the packets all over the network, things regarding capturing didn’t
change.
At the next stage, Ethernet switches became widely available. This complicated
things a lot. When capturing traffic on a computer connected to a switch,
usually the switch will only forward packets to the computer, which are directed
to it, or to all computers (broadcasts). It’s much the same like deactivating
the promiscuous mode of the capturing network card.
There are some ways to circumvent this.
Many vendor’s switches support a feature known as “port spanning” or “port
mirroring” in which all of the traffic to and from port A are also sent out
port B.
=== Examples of troubleshooting
Troubleshooting often requires a reasonable knowledge of the protocols in
question. However, as Wireshark will often give you some good hints, you might
get an idea of what is going wrong simply by looking in the packets being
exchanged.
// End of WSUG Chapter 4
|
