diff options
Diffstat (limited to 'nuttx/configs/vsn/include/board.h')
-rw-r--r-- | nuttx/configs/vsn/include/board.h | 45 |
1 files changed, 0 insertions, 45 deletions
diff --git a/nuttx/configs/vsn/include/board.h b/nuttx/configs/vsn/include/board.h index 733f1fc324..a1a30c4b19 100644 --- a/nuttx/configs/vsn/include/board.h +++ b/nuttx/configs/vsn/include/board.h @@ -55,51 +55,6 @@ /************************************************************************************ * Definitions ************************************************************************************/ - -/* Board Peripheral Assignment - * - * RS232/Power connector: - * - USART1, is the default bootloader and console - * - * Sensor Connector: - * Digital: - * - GPIOs: PB10, PB11 (or even TIM2 CH3 and CH4) - * - USART3 - * - I2C2 - * Analog: - * - ADC1 - * Supporting Analog Circuitry (not seen outside) - * - RefTap (TIM3_CH3) - * - Power PWM Out (TIM8_CH1 / TIM3_CH1) - * - Filtered Out (TIM3_CH4) - * (TIM8 could run at lower frequency, while TIM3 must run at highest possible) - * - Gain selection muxed with SDcard I/Os. - * - * Radio connector: - * - UART3 / UART4 - * - SPI2 - * - I2C1 (remapped pins vs. Expansion connector) - * - CAN - * - TIM4 CH[3:4] - * - * Expansion connector: - * - WakeUp Pin - * - System Wide Reset - * - SPI1 is wired to expansion port - * - I2C1 - * - USART2 [Rx, Tx, CTS, RTS] - * - DAC [0:1] - * - ADC2 on pins [0:7] - * - TIM2 Channels [1:4] - * - TIM5 Channels [1:4] - * - * Onboard Components: - * - SPI3 has direct connection with FRAM - * - SDCard, conencts the microSD and shares the control lines with Sensor Interface - * to select Amplifier Gain - * - ADC3 is used also for power management (can be shared with ADC1 on sensor connector - * if not used) - */ /* Clocking *************************************************************************/ |