1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
|
#include <stdint.h>
#include <stdio.h>
#include <debug.h>
#include <memory.h>
#include <rffe.h>
#include <calypso/tsp.h>
#include <rf/trf6151.h>
/* This is a value that has been measured on the C123 by Harald: 71dBm,
it is the difference between the input level at the antenna and what
the DSP reports, subtracted by the total gain of the TRF6151 */
#define SYSTEM_INHERENT_GAIN 71
/* describe how the RF frontend is wired on the Openmoko GTA0x boards */
#define RITA_RESET TSPACT(0) /* Reset of the Rita TRF6151 */
#define PA_ENABLE TSPACT(9) /* Enable the Power Amplifier */
#define GSM_TXEN TSPACT(3) /* PA GSM switch, low-active */
/* All VCn controls are low-active */
#define ASM_VC1 TSPACT(2) /* Antenna switch VC1 */
#define ASM_VC2 TSPACT(1) /* Antenna switch VC2 */
#define ASM_VC3 TSPACT(4) /* Antenna switch VC3 */
#define IOTA_STROBE TSPEN0 /* Strobe for the Iota TSP */
#define RITA_STROBE TSPEN2 /* Strobe for the Rita TSP */
/* switch RF Frontend Mode */
void rffe_mode(enum gsm_band band, int tx)
{
uint16_t tspact = tsp_act_state();
/* First we mask off all bits from the state cache */
tspact &= ~PA_ENABLE;
tspact |= GSM_TXEN; /* low-active */
tspact |= ASM_VC1 | ASM_VC2 | ASM_VC3; /* low-active */
switch (band) {
case GSM_BAND_850:
case GSM_BAND_900:
case GSM_BAND_1800:
break;
case GSM_BAND_1900:
tspact &= ~ASM_VC2;
break;
default:
/* TODO return/signal error here */
break;
}
#ifdef CONFIG_TX_ENABLE
/* Then we selectively set the bits on, if required */
if (tx) {
// TODO: Implement tx
}
#endif /* TRANSMIT_SUPPORT */
tsp_act_update(tspact);
}
#define MCU_SW_TRACE 0xfffef00e
#define ARM_CONF_REG 0xfffef006
void rffe_init(void)
{
uint16_t reg;
reg = readw(ARM_CONF_REG);
reg &= ~ (1 << 7); /* TSPACT4 I/O function, not nRDYMEM */
writew(reg, ARM_CONF_REG);
reg = readw(MCU_SW_TRACE);
reg &= ~(1 << 1); /* TSPACT9 I/O function, not MAS(1) */
writew(reg, MCU_SW_TRACE);
}
uint8_t rffe_get_gain(void)
{
return trf6151_get_gain();
}
const uint8_t system_inherent_gain = SYSTEM_INHERENT_GAIN;
#define to_dbm8(x) ((x)*8)
/* Given the expected input level of exp_inp dBm/8 and the target of target_bb
* dBm8, configure the RF Frontend with the respective gain */
void rffe_set_gain(int16_t exp_inp, int16_t target_bb)
{
trf6151_compute_gain(exp_inp, target_bb);
}
void rffe_rx_win_ctrl(int16_t exp_inp, int16_t target_bb)
{
/* FIXME */
}
|
