1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
|
#include <stdint.h>
#include <stdio.h>
#include <debug.h>
#include <memory.h>
#include <rffe.h>
#include <calypso/tsp.h>
#include <rf/trf6151.h>
/* This is a value that has been measured on the C123 by Harald: 71dBm,
it is the difference between the input level at the antenna and what
the DSP reports, subtracted by the total gain of the TRF6151 */
#define SYSTEM_INHERENT_GAIN 71
/* describe how the RF frontend is wired on the Motorola E86 board (C139/C140) */
#define RITA_RESET TSPACT(0) /* Reset of the Rita TRF6151 */
#define PA_ENABLE TSPACT(1) /* Enable the Power Amplifier */
#define DCS_TX TSPACT(6) /* DCS Transmit Enable */
#define GSM_TX1 TSPACT(8) /* GSM Transmit Enable 1 */
/* in order to save a transistor, the E86 has a second signal for GSM TX */
#define GSM_TX2 TSPACT(2) /* GSM Transmit Enable 2 */
#define IOTA_STROBE TSPEN(0) /* Strobe for the Iota TSP */
#define RITA_STROBE TSPEN(2) /* Strobe for the Rita TSP */
/* switch RF Frontend Mode */
void rffe_mode(enum gsm_band band, int tx)
{
uint16_t tspact = tsp_act_state();
/* First we mask off all bits from the state cache */
tspact &= ~(PA_ENABLE);
tspact |= DCS_TX | GSM_TX1 | GSM_TX2; /* low-active */
#ifdef CONFIG_TX_ENABLE
/* Then we selectively set the bits on, if required */
if (tx) {
if (band == GSM_BAND_850 || band == GSM_BAND_900)
tspact &= ~(GSM_TX1 | GSM_TX2);
else
tspact &= ~DCS_TX;
tspact |= PA_ENABLE;
}
#endif /* TRANSMIT_SUPPORT */
tsp_act_update(tspact);
}
/* Returns RF wiring */
uint32_t rffe_get_rx_ports(void)
{
return (1 << PORT_LO) | (1 << PORT_DCS1800);
}
uint32_t rffe_get_tx_ports(void)
{
return (1 << PORT_LO) | (1 << PORT_HI);
}
/* Returns need for IQ swap */
int rffe_iq_swapped(uint16_t band_arfcn, int tx)
{
return trf6151_iq_swapped(band_arfcn, tx);
}
#define MCU_SW_TRACE 0xfffef00e
#define ARM_CONF_REG 0xfffef006
void rffe_init(void)
{
uint16_t reg;
reg = readw(ARM_CONF_REG);
reg &= ~ (1 << 5); /* TSPACT6 I/O function, not nCS6 */
writew(reg, ARM_CONF_REG);
reg = readw(MCU_SW_TRACE);
reg &= ~(1 << 5); /* TSPACT8 I/O function, not nMREQ */
writew(reg, MCU_SW_TRACE);
/* Configure the TSPEN which is connected to the TWL3025 */
tsp_setup(IOTA_STROBE, 1, 0, 0);
trf6151_init(RITA_STROBE, RITA_RESET);
}
uint8_t rffe_get_gain(void)
{
return trf6151_get_gain();
}
void rffe_set_gain(uint8_t dbm)
{
trf6151_set_gain(dbm);
}
const uint8_t system_inherent_gain = SYSTEM_INHERENT_GAIN;
/* Given the expected input level of exp_inp dBm/8 and the target of target_bb
* dBm8, configure the RF Frontend with the respective gain */
void rffe_compute_gain(int16_t exp_inp, int16_t target_bb)
{
trf6151_compute_gain(exp_inp, target_bb);
}
void rffe_rx_win_ctrl(int16_t exp_inp, int16_t target_bb)
{
/* FIXME */
}
|
