From a07764f0d9426ae5b18b1bc4f2c2951da88cb677 Mon Sep 17 00:00:00 2001 From: Martin Hauke Date: Fri, 1 Jan 2021 22:11:48 +0100 Subject: Fixed typos in cli output and source code comments --- src/cnetz/cnetz.c | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-) (limited to 'src/cnetz/cnetz.c') diff --git a/src/cnetz/cnetz.c b/src/cnetz/cnetz.c index bc74f7d..08cb668 100644 --- a/src/cnetz/cnetz.c +++ b/src/cnetz/cnetz.c @@ -42,7 +42,7 @@ * If no SpK is available, the call is rejected. If queue (Warteschlange) is * enabled, WSK(R) is scheduled. After transmission, the state changes to * TRANS_MT_QUEUE. Upon timeout (no channel becomes available), the call is - * rejected by scheduling VA(R). Upon available channel the call proceeeds with + * rejected by scheduling VA(R). Upon available channel the call proceeds with * VAK(R) as described above. * * If an MO (mobile originating) call is made (received VWG(K)), a transaction @@ -57,11 +57,11 @@ * (Warteschlange) is enabled, WWBP(R) is scheduled. After transmission, the * state is changed to TRANS_MO_QUEUE. Upon timeout (no channel becomes * available), the call is rejected by scheduling VA(R). Upon available channel - * the call proceeeds with VAG(R) as described above. + * the call proceeds with VAG(R) as described above. * * Switching to SpK is performed two time slots after transmitting VAK(R) or * VAG(R). The timer is started. The schedulers schedules 8 times BQ(K) and - * awaits at least one BEL(K). If BEK(K) is received, the timer is stoped. If + * awaits at least one BEL(K). If BEK(K) is received, the timer is stopped. If * BQ(K) was sent at least 8 times and if timer is stopped, the scheduler * schedules VHQ(K). If no BEL(K) was received, AFK(K) is scheduled N_AFKT * times, then the process on OgK (WBP+VAG or VAK) is repeated N times. @@ -114,7 +114,7 @@ /* * Notes on the combined channel hack: * - * For combined SpK+OgK hack, the channel is used as SpK as last choise. This + * For combined SpK+OgK hack, the channel is used as SpK as last choice. This * allows to use only one transceiver for making C-Netz to work. Also it allows * to use all transceivers for simultanious phone calls. Some phones may not * work with that. @@ -508,7 +508,7 @@ void cnetz_go_idle(cnetz_t *cnetz) /* set scheduler to OgK or turn off SpK */ if (cnetz->dsp_mode == DSP_MODE_SPK_K || cnetz->dsp_mode == DSP_MODE_SPK_V) { - /* switch next frame after distributed signaling boundary (mutliple of 8 slots) */ + /* switch next frame after distributed signaling boundary (multiple of 8 slots) */ cnetz_set_sched_dsp_mode(cnetz, (atoi(cnetz->sender.kanal) == CNETZ_OGK_KANAL) ? DSP_MODE_OGK : DSP_MODE_OFF, (cnetz->sched_ts + 8) & 24); } else { /* switch next frame */ -- cgit v1.2.3