From 58721eb350f79c50f50a1d4f2e1eec5f6037a61f Mon Sep 17 00:00:00 2001 From: Jonathan Brielmaier Date: Wed, 25 May 2016 15:01:11 +0200 Subject: fix various typos across all manuals --- doc/manuals/chapters/configuration.adoc | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) (limited to 'doc/manuals/chapters/configuration.adoc') diff --git a/doc/manuals/chapters/configuration.adoc b/doc/manuals/chapters/configuration.adoc index 1a86f320..bcf3ad7c 100644 --- a/doc/manuals/chapters/configuration.adoc +++ b/doc/manuals/chapters/configuration.adoc @@ -59,7 +59,7 @@ reached, a higher coding scheme is chosen. You can use the `cs link-quality-ranges cs1 <0-35> cs2 <0-35> <0-35> cs3 <0-35> <0-35> cs4 <0-35>` command at the `pcu` VTY config node to tune -the link quality ranges for the respecive coding schemes. +the link quality ranges for the respective coding schemes. ==== Data Size based CS downgrade Threshold @@ -114,7 +114,7 @@ filter). ==== Normal BSSGP Flow Control Tuning parameters You can use the following commands at the `pcu` VTY config node to tune -the the BSSGP flow control parameters: +the BSSGP flow control parameters: `flow-control-interval <1-10>`:: configure the interval (in seconds) between subsequent flow @@ -185,7 +185,7 @@ parameters. You can set those parameters at the `pcu` VTY config node as follows: `alpha <0-10>`:: - Alpha parameter for MS power contrl in units of 0.1. + Alpha parameter for MS power control in units of 0.1. Make sure to set the alpha value at System Information 13 (in the BSC), too! `gamma <0-62>`:: -- cgit v1.2.3