| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
Together with the 'generic' structures which used to be shared between
osmo-bsc and osmo-bts some time ago, we also have the following
osmo-bts-trx specific structures (in hierarchical order):
- struct l1sched_trx (struct gsm_bts_trx),
- struct l1sched_ts (struct gsm_bts_trx_ts),
- struct l1sched_chan_state (struct gsm_lchan).
These structures are not integrated into the tree of the generic
structures, but maintained in a _separate tree_ instead. Until
recently, only the 'l1sched_trx' had a pointer to generic
'gsm_bts_trx', so in order to find the corresponding 'gsm_lchan' for
'l1sched_chan_state' one would need to traverse all the way up to
'l1sched_trx' and then tracerse another three backwards.
+ gsm_network
|
--+ gsm_bts (0..255)
|
--+ l1sched_trx --------------------> gsm_bts_trx (0..255)
| |
--+ l1sched_trx_ts --+ gsm_bts_trx_ts (8)
| |
--+ l1sched_chan_state --+ gsm_lchan (up to 8)
I find this architecture a bit over-complicated, especially given
that 'l1sched_trx' is kind of a dummy node containing nothing else
than a pointer to 'gsm_bts_trx' and the list of 'l1sched_trx_ts'.
In this path I slightly change the architecture as follows:
+ gsm_network
|
--+ gsm_bts (0..255)
|
--+ gsm_bts_trx (0..255)
|
--+ l1sched_trx_ts <----------------> gsm_bts_trx_ts (8)
| |
--+ l1sched_chan_state --+ gsm_lchan (up to 8)
Note that unfortunately we cannot 1:1 map 'l1sched_chan_state' to
'gsm_lchan' (like we do for 'l1sched_trx_ts' and 'gsm_bts_trx_ts')
because there is no direct mapping. The former is a higl-level
representation of a logical channel, while the later represents
one specific logical channel type like FCCH, SDCCH/0 or SACCH/0.
osmo-bts-virtual re-uses the osmo-bts-trx hierarchy, so it's also
affected by this change.
Change-Id: I7c4379e43a25e9d858d582a99bf6c4b65c9af481
|
|
Historically the logical channel handlers like rx_data_fn() used to accept
quite a lot of arguments. With the introduction of additional measurement
parameters it has become clear that we need to group the arguments into
structures. This is why both 'trx_{dl,ul}_burst_{req,ind}' structures
were introduced.
However, both channel type and burst ID were kept untouched, so until
now we had them being passed between the scheduler functions here and
there. This change is a logical conclusion of the original change
mentioned above.
As a part of this change, the new LOGL1SB() macro is introduced. It
does accept a pointer to 'trx_{dl,ul}_burst_{req,ind}' and expands the
context information for the old LOGL1S() macro.
Change-Id: Ic5a02b074662b3e429bf18e05a982f3f3e7b7444
|
|
It's easier to maintain the logical channel handlers in separate
files, rather than in a huge one (scheduler_trx.c, ~2k lines).
Change-Id: Ie5663fd90596b4800a4546675a323250bbb24c80
|
