; V6PCI/V12PCI config file for VoiceTronix Hardware
; Options
; For [general] section
; type = v12pci|v6pci|v4pci
; cards = number of cards
; For [interface] section
; board = board_number (1, 2, 3, ...)
; channel = channel_number (1,2,3...)
; mode = fxo|immediate|dialtone -- for type of line and line handling
; context = starting context
; echocancel = on|off (on by default of v4pci, off by default for others)
; callerid = on|off (to collect caller ID if available between 1st/2nd rings)
; UseLoopDrop = 0|1 (enables the use of Loop Drop detection, on by default in
;                    some cases spurious loop-drops can cause unexpected 
;                    hangup detection)
; 
; Gain settings
; txgain  => Transmit Software Gain (-12 => 12)
; rxgain  => Receive Software Gain (-12 => 12)
; txhwgain => Transmit hardware gain (-12 => 12)
; rxhwgain => Receive Hardware gain (-12 => 12)
;
; These are advanced settings and only mentioned for fullnes.
; bal1  => Hybrid balance codec register 1
; bal2  => Hybrid balance codec register 2
; bal3  => Hybrid balance codec register 3
;
; Dial translations - if you want a pause or hook-flash in your dial string
; you can use "w" for pause (wait) or "f" for "hook-flash", eg:
; exten => _9XXX,1,Dial(vpb/g1/ww${EXTEN:${TRUNKMSD}})
;
;

[general]
type = v12pci
;type = v6pci
;type = v4pci
cards = 1

[interfaces]

board = 1
echocancel = on


; For OpenLine4 cards
;context = demo
;mode = fxo
;channel = 1
;channel = 2
;channel = 3
;channel = 4

; For OpenSwith12 with jumpers at factory default
context = demo
mode = fxo
channel = 9
channel = 10
channel = 11
channel = 12

context = local
mode = dialtone
channel = 1
channel = 2
channel = 3
channel = 4
channel = 5
channel = 6
channel = 7
channel = 8
;
; For OpenSwitch6
; Note that V6PCI channel numbers start at 7!
;context = demo
;mode = fxo
;channel = 7
;channel = 8

;mode = dialtone
;channel = 9
;channel = 10
;channel = 11
;channel = 12