[general] ; General config options, with default values shown. ; You should use one section per device, with [general] being used ; for the device. ; debug = 0x0 ; misc debug flags, default is 0 ; Set the device to use for I/O ; devicenum = 0 ; Set hardware type here ; hdwtype=0 ; 0=limey, 1=sph ; rxboost=0 ; no rx gain boost ; rxctcssrelax=1 ; reduce talkoff from radios w/o CTCSS Tx HPF ; rxctcssfreq=100.0 ; rx ctcss freq in floating point. must be in table ; txctcssfreq=100.0 ; tx ctcss freq, any frequency permitted ; carrierfrom=dsp ;no,usb,usbinvert,dsp,vox ; ctcssfrom=dsp ;no,usb,dsp ; rxdemod=flat ; input type from radio: no,speaker,flat ; txprelim=yes ; output is pre-emphasised and limited ; txtoctype=no ; no,phase,notone ; txmixa=composite ;no,voice,tone,composite,auxvoice ; txmixb=no ;no,voice,tone,composite,auxvoice ; invertptt=0 ;------------------------------ JITTER BUFFER CONFIGURATION -------------------------- ; jbenable = yes ; Enables the use of a jitterbuffer on the receiving side of an ; USBRADIO channel. Defaults to "no". An enabled jitterbuffer will ; be used only if the sending side can create and the receiving ; side can not accept jitter. The USBRADIO channel can't accept jitter, ; thus an enabled jitterbuffer on the receive USBRADIO side will always ; be used if the sending side can create jitter. ; jbmaxsize = 200 ; Max length of the jitterbuffer in milliseconds. ; jbresyncthreshold = 1000 ; Jump in the frame timestamps over which the jitterbuffer is ; resynchronized. Useful to improve the quality of the voice, with ; big jumps in/broken timestamps, usualy sent from exotic devices ; and programs. Defaults to 1000. ; jbimpl = fixed ; Jitterbuffer implementation, used on the receiving side of an USBRADIO ; channel. Two implementations are currenlty available - "fixed" ; (with size always equals to jbmax-size) and "adaptive" (with ; variable size, actually the new jb of IAX2). Defaults to fixed. ; jbtargetextra = 40 ; This option only affects the jb when 'jbimpl = adaptive' is set. ; The option represents the number of milliseconds by which the new ; jitter buffer will pad its size. the default is 40, so without ; modification, the new jitter buffer will set its size to the jitter ; value plus 40 milliseconds. increasing this value may help if your ; network normally has low jitter, but occasionally has spikes. ; jblog = no ; Enables jitterbuffer frame logging. Defaults to "no". ;-----------------------------------------------------------------------------------