; ; Configuration for chan_console, a cross-platform console channel driver. ; [general] ; Set this option to "yes" to enable automatically answering calls on the ; console. This is very useful if the console is used as an intercom. ; The default value is "no". ; ;autoanswer = no ; Set the default context to use for outgoing calls. This can be overridden by ; dialing some extension@context, unless the overridecontext option is enabled. ; The default is "default". ; ;context = default ; Set the default extension to use for outgoing calls. The default is "s". ; ;extension = s ; Set the default CallerID for created channels. ; ;callerid = MyName Here <(256) 428-6000> ; Set the default language for created channels. ; ;language = en ; If you set overridecontext to 'yes', then the whole dial string ; will be interpreted as an extension, which is extremely useful ; to dial SIP, IAX and other extensions which use the '@' character. ; The default is "no". ; ;overridecontext = no ; if 'no', the last @ will start the context ; if 'yes' the whole string is an extension. ; Default Music on Hold class to use when this channel is placed on hold in ; the case that the music class is not set on the channel with ; Set(CHANNEL(musicclass)=whatever) in the dialplan and the peer channel ; putting this one on hold did not suggest a class to use. ; ;mohinterpret=default ;------------------------------ JITTER BUFFER CONFIGURATION -------------------------- ; jbenable = yes ; Enables the use of a jitterbuffer on the receiving side of an ; Console channel. Defaults to "no". An enabled jitterbuffer will ; be used only if the sending side can create and the receiving ; side can not accept jitter. The Console channel can't accept jitter, ; thus an enabled jitterbuffer on the receive Console side will always ; be used if the sending side can create jitter. ; jbmaxsize = 200 ; Max length of the jitterbuffer in milliseconds. ; jbresyncthreshold = 1000 ; Jump in the frame timestamps over which the jitterbuffer is ; resynchronized. Useful to improve the quality of the voice, with ; big jumps in/broken timestamps, usually sent from exotic devices ; and programs. Defaults to 1000. ; jbimpl = fixed ; Jitterbuffer implementation, used on the receiving side of a Console ; channel. Two implementations are currently available - "fixed" ; (with size always equals to jbmax-size) and "adaptive" (with ; variable size, actually the new jb of IAX2). Defaults to fixed. ; jbtargetextra = 40 ; This option only affects the jb when 'jbimpl = adaptive' is set. ; The option represents the number of milliseconds by which the new ; jitter buffer will pad its size. the default is 40, so without ; modification, the new jitter buffer will set its size to the jitter ; value plus 40 milliseconds. increasing this value may help if your ; network normally has low jitter, but occasionally has spikes. ; jblog = no ; Enables jitterbuffer frame logging. Defaults to "no". ;----------------------------------------------------------------------------------- ; ; Any configuration context defined beyond the [general] section configures ; specific devices for use. ; [default] input_device = default ; When configuring an input device and output device, output_device = default ; use the name that you see when you run the "console ; list available" CLI command. If you say "default", the ; system default input and output devices will be used. autoanswer = no context = default extension = s callerid = MyName Here <(256) 428-6000> language = en overridecontext = no mohinterpret = default active = yes ; This option should only be set for one console. ; It means that it is the active console to be ; used from the Asterisk CLI.