diff options
Diffstat (limited to 'trunk/configs/usbradio.conf.sample')
| -rw-r--r-- | trunk/configs/usbradio.conf.sample | 54 |
1 files changed, 54 insertions, 0 deletions
diff --git a/trunk/configs/usbradio.conf.sample b/trunk/configs/usbradio.conf.sample new file mode 100644 index 000000000..5ba9815ca --- /dev/null +++ b/trunk/configs/usbradio.conf.sample @@ -0,0 +1,54 @@ +[general] + +; General config options, with default values shown. +; You should use one section per device, with [general] being used +; for the device. + +; debug = 0x0 ; misc debug flags, default is 0 + +; Set the device to use for I/O +; devicenum = 0 +; Set hardware type here +; hdwtype=0 ; 0=limey, 1=sph + +; rxboost=0 ; no rx gain boost +; rxctcssrelax=1 ; reduce talkoff from radios w/o CTCSS Tx HPF +; rxctcssfreq=100.0 ; rx ctcss freq in floating point. must be in table +; txctcssfreq=100.0 ; tx ctcss freq, any frequency permitted + +; carrierfrom=dsp ;no,usb,usbinvert,dsp,vox +; ctcssfrom=dsp ;no,usb,dsp + +; rxdemod=flat ; input type from radio: no,speaker,flat +; txprelim=yes ; output is pre-emphasised and limited +; txtoctype=no ; no,phase,notone + +; txmixa=composite ;no,voice,tone,composite,auxvoice +; txmixb=no ;no,voice,tone,composite,auxvoice + +; invertptt=0 + +;------------------------------ JITTER BUFFER CONFIGURATION -------------------------- +; jbenable = yes ; Enables the use of a jitterbuffer on the receiving side of an + ; USBRADIO channel. Defaults to "no". An enabled jitterbuffer will + ; be used only if the sending side can create and the receiving + ; side can not accept jitter. The USBRADIO channel can't accept jitter, + ; thus an enabled jitterbuffer on the receive USBRADIO side will always + ; be used if the sending side can create jitter. + +; jbmaxsize = 200 ; Max length of the jitterbuffer in milliseconds. + +; jbresyncthreshold = 1000 ; Jump in the frame timestamps over which the jitterbuffer is + ; resynchronized. Useful to improve the quality of the voice, with + ; big jumps in/broken timestamps, usualy sent from exotic devices + ; and programs. Defaults to 1000. + +; jbimpl = fixed ; Jitterbuffer implementation, used on the receiving side of an USBRADIO + ; channel. Two implementations are currenlty available - "fixed" + ; (with size always equals to jbmax-size) and "adaptive" (with + ; variable size, actually the new jb of IAX2). Defaults to fixed. + +; jblog = no ; Enables jitterbuffer frame logging. Defaults to "no". +;----------------------------------------------------------------------------------- + + |