diff options
Diffstat (limited to 'trunk/configs/phone.conf.sample')
| -rw-r--r-- | trunk/configs/phone.conf.sample | 51 |
1 files changed, 51 insertions, 0 deletions
diff --git a/trunk/configs/phone.conf.sample b/trunk/configs/phone.conf.sample new file mode 100644 index 000000000..17204501e --- /dev/null +++ b/trunk/configs/phone.conf.sample @@ -0,0 +1,51 @@ +; +; Linux Telephony Interface +; +; Configuration file +; +[interfaces] +; +; Select a mode, either the phone jack provides dialtone, reads digits, +; then starts PBX with the given extension (dialtone mode), or +; immediately provides the PBX without reading any digits or providing +; any dialtone (this is the immediate mode, the default). Also, you +; can set the mode to "fxo" if you have a linejack to make it operate +; properly. If you are using a Sigma Designs board you may set this to +; "sig". +; +mode=immediate +;mode=dialtone +;mode=fxo +;mode=sig +; +; You can decide which format to use by default, "g723.1", "g729", or "slinear". +; Note that g729 is only supported for Sigma Designs boards. +; XXX Be careful, sometimes the card causes kernel panics when running +; in signed linear mode for some reason... XXX +; +format=slinear +;format=g723.1 +;format=g729 +; +; And set the echo cancellation to "off", "low", "medium", and "high". +; This is not supported on all phones. +; +echocancel=medium +; +; You can optionally use VAD/CNG silence suppression +; +;silencesupression=yes +; +; List all devices we can use. Contexts may also be specified +; +;context=local +; +; You can set txgain and rxgain for each device in the same way as context. +; If you want to change default gain value (1.0 =~ 100%) for device, simple +; add txgain or rxgain line before device line. But remember, if you change +; volume all cards listed below will be affected by these values. You can +; use float values (1.0, 0.5, 2.0) or percentage values (100%, 150%, 50%). +; +;txgain=100% +;rxgain=1.0 +;device => /dev/phone0 |