diff options
Diffstat (limited to 'doc/misdn.txt')
-rw-r--r-- | doc/misdn.txt | 12 |
1 files changed, 6 insertions, 6 deletions
diff --git a/doc/misdn.txt b/doc/misdn.txt index db4942ac4..5e96975ec 100644 --- a/doc/misdn.txt +++ b/doc/misdn.txt @@ -122,7 +122,7 @@ contain the ports variable which mean the mISDN Ports. Here you can add multiple ports, comma separated. Espacially for TE-Mode Ports there is a msns option. This option tells the -chan_misdn driver to listen for incomming calls with the given msns, you can +chan_misdn driver to listen for incoming calls with the given msns, you can insert a '*' as single msn, which leads in getting every incoming call (if you want to share on PMP TE S0 with a asterisk and a phone or isdn card you should insert here the msns which you'll like to give the Asterisk). Finally a @@ -148,7 +148,7 @@ The available Optchars are: n - don't detect dtmf tones on called channel h - make digital outgoing call c - make crypted outgoing call, param is keyindex - e - perform echo cancelation on this channel, + e - perform echo cancellation on this channel, takes taps as arguments (32,64,128,256) s - send Non Inband DTMF as inband vr - rxgain control @@ -203,7 +203,7 @@ Now you should see the misdn cli commands: -> config (shows the configuration options) -> channels (shows the current active misdn channels) -> channel (shows details about the given misdn channels) - -> stacks (shows the currend ports, there protocols and states) + -> stacks (shows the current ports, their protocols and states) -> fullstacks (shows the current active and inactive misdn channels) - restart @@ -255,7 +255,7 @@ exten => _0X.,1,Dial(mISDN/g:${OUT_GROUP}/${EXTEN:1}) exten => _1X.,1,Dial(mISDN/g:${OUT_GROUP}/${EXTEN:1}/:dHello) exten => _1X.,1,Dial(mISDN/g:${OUT_GROUP}/${EXTEN:1}/:dHello Test:n) -In the last line you will notice the last argument (Hello), this is sended +On the last line, you will notice the last argument (Hello); this is sent as Display Message to the Phone. Known Problems @@ -265,11 +265,11 @@ Known Problems -> You need to use ztdummy as dummy zaptel interface for the iax timing in trunking mode, simply grab libpri, zaptel and compile them (i think you need -to modify the makefile in zaptel to add ztdummy to the defaultly compiled +to modify the makefile in zaptel to add ztdummy to the default compiled modules) then modprobe ztdummy, this resolves the problem. -* I cannot hear any tone after succesfull CONNECT to other end +* I cannot hear any tone after a successful CONNECT to the other end -> you forgot to load mISDNdsp, which is now needed by chan_misdn for switching and dtmf tone detection |