diff options
Diffstat (limited to 'configs')
| -rw-r--r-- | configs/usbradio.conf.sample | 54 |
1 files changed, 0 insertions, 54 deletions
diff --git a/configs/usbradio.conf.sample b/configs/usbradio.conf.sample deleted file mode 100644 index 5ba9815ca..000000000 --- a/configs/usbradio.conf.sample +++ /dev/null @@ -1,54 +0,0 @@ -[general] - -; General config options, with default values shown. -; You should use one section per device, with [general] being used -; for the device. - -; debug = 0x0 ; misc debug flags, default is 0 - -; Set the device to use for I/O -; devicenum = 0 -; Set hardware type here -; hdwtype=0 ; 0=limey, 1=sph - -; rxboost=0 ; no rx gain boost -; rxctcssrelax=1 ; reduce talkoff from radios w/o CTCSS Tx HPF -; rxctcssfreq=100.0 ; rx ctcss freq in floating point. must be in table -; txctcssfreq=100.0 ; tx ctcss freq, any frequency permitted - -; carrierfrom=dsp ;no,usb,usbinvert,dsp,vox -; ctcssfrom=dsp ;no,usb,dsp - -; rxdemod=flat ; input type from radio: no,speaker,flat -; txprelim=yes ; output is pre-emphasised and limited -; txtoctype=no ; no,phase,notone - -; txmixa=composite ;no,voice,tone,composite,auxvoice -; txmixb=no ;no,voice,tone,composite,auxvoice - -; invertptt=0 - -;------------------------------ JITTER BUFFER CONFIGURATION -------------------------- -; jbenable = yes ; Enables the use of a jitterbuffer on the receiving side of an - ; USBRADIO channel. Defaults to "no". An enabled jitterbuffer will - ; be used only if the sending side can create and the receiving - ; side can not accept jitter. The USBRADIO channel can't accept jitter, - ; thus an enabled jitterbuffer on the receive USBRADIO side will always - ; be used if the sending side can create jitter. - -; jbmaxsize = 200 ; Max length of the jitterbuffer in milliseconds. - -; jbresyncthreshold = 1000 ; Jump in the frame timestamps over which the jitterbuffer is - ; resynchronized. Useful to improve the quality of the voice, with - ; big jumps in/broken timestamps, usualy sent from exotic devices - ; and programs. Defaults to 1000. - -; jbimpl = fixed ; Jitterbuffer implementation, used on the receiving side of an USBRADIO - ; channel. Two implementations are currenlty available - "fixed" - ; (with size always equals to jbmax-size) and "adaptive" (with - ; variable size, actually the new jb of IAX2). Defaults to fixed. - -; jblog = no ; Enables jitterbuffer frame logging. Defaults to "no". -;----------------------------------------------------------------------------------- - - |