diff options
Diffstat (limited to '1.2-netsec/configs/phone.conf.sample')
| -rw-r--r-- | 1.2-netsec/configs/phone.conf.sample | 47 |
1 files changed, 0 insertions, 47 deletions
diff --git a/1.2-netsec/configs/phone.conf.sample b/1.2-netsec/configs/phone.conf.sample deleted file mode 100644 index ca028f9a1..000000000 --- a/1.2-netsec/configs/phone.conf.sample +++ /dev/null @@ -1,47 +0,0 @@ -; -; Linux Telephony Interface -; -; Configuration file -; -[interfaces] -; -; Select a mode, either the phone jack provides dialtone, reads digits, -; then starts PBX with the given extension (dialtone mode), or -; immediately provides the PBX without reading any digits or providing -; any dialtone (this is the immediate mode, the default). Also, you -; can set the mode to "fxo" if you have a linejack to make it operate -; properly. -; -mode=immediate -;mode=dialtone -;mode=fxo -; -; You can decide which format to use by default, "g723.1" or "slinear". -; XXX Be careful, sometimes the card causes kernel panics when running -; in signed linear mode for some reason... XXX -; -format=slinear -;format=g723.1 -; -; And set the echo cancellation to "off", "low", "medium", and "high". -; This is not supported on all phones. -; -echocancel=medium -; -; You can optionally use VAD/CNG silence supression -; -;silencesupression=yes -; -; List all devices we can use. Contexts may also be specified -; -;context=local -; -; You can set txgain and rxgain for each device in the same way as context. -; If you want to change default gain value (1.0 =~ 100%) for device, simple -; add txgain or rxgain line before device line. But rememeber, if you change -; volume all cards listed below will be affected by these values. You can -; use float values (1.0, 0.5, 2.0) or percentage values (100%, 150%, 50%). -; -;txgain=100% -;rxgain=1.0 -;device => /dev/phone0 |