1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
|
#include <stdint.h>
#include <stdio.h>
#include <debug.h>
#include <memory.h>
#include <rffe.h>
#include <calypso/tsp.h>
#include <rf/trf6151.h>
/* This is a value that has been measured on the C123 by Harald: 71dBm,
it is the difference between the input level at the antenna and what
the DSP reports, subtracted by the total gain of the TRF6151 */
#define SYSTEM_INHERENT_GAIN 71
/* describe how the RF frontend is wired on the Openmoko GTA0x boards */
#define RITA_RESET TSPACT(0) /* Reset of the Rita TRF6151 */
#define PA_ENABLE TSPACT(9) /* Enable the Power Amplifier */
#define GSM_TXEN TSPACT(3) /* PA GSM switch, low-active */
/* All VCn controls are low-active */
#define ASM_VC1 TSPACT(2) /* Antenna switch VC1 */
#define ASM_VC2 TSPACT(1) /* Antenna switch VC2 */
#define ASM_VC3 TSPACT(4) /* Antenna switch VC3 */
#define IOTA_STROBE TSPEN(0) /* Strobe for the Iota TSP */
#define RITA_STROBE TSPEN(2) /* Strobe for the Rita TSP */
/* switch RF Frontend Mode */
void rffe_mode(enum gsm_band band, int tx)
{
uint16_t tspact = tsp_act_state();
/* First we mask off all bits from the state cache */
tspact &= ~PA_ENABLE;
tspact &= ~GSM_TXEN;
tspact |= ASM_VC1 | ASM_VC2 | ASM_VC3; /* low-active */
switch (band) {
case GSM_BAND_850:
case GSM_BAND_900:
case GSM_BAND_1800:
break;
case GSM_BAND_1900:
tspact &= ~ASM_VC2;
break;
default:
/* TODO return/signal error here */
break;
}
#ifdef CONFIG_TX_ENABLE
/* Then we selectively set the bits on, if required */
if (tx) {
switch (band) {
case GSM_BAND_850:
case GSM_BAND_900:
tspact &= ~ASM_VC3;
break;
case GSM_BAND_1800:
case GSM_BAND_1900:
tspact &= ~ASM_VC1;
tspact |= ASM_VC2;
tspact |= GSM_TXEN;
break;
default:
break;
}
tspact |= PA_ENABLE;
}
#endif /* TRANSMIT_SUPPORT */
tsp_act_update(tspact);
}
/* Returns RF wiring */
uint32_t rffe_get_rx_ports(void)
{
return (1 << PORT_LO) | (1 << PORT_DCS1800) | (1 << PORT_PCS1900);
}
uint32_t rffe_get_tx_ports(void)
{
return (1 << PORT_LO) | (1 << PORT_HI);
}
/* Returns need for IQ swap */
int rffe_iq_swapped(uint16_t band_arfcn, int tx)
{
return trf6151_iq_swapped(band_arfcn, tx);
}
#define MCU_SW_TRACE 0xfffef00e
#define ARM_CONF_REG 0xfffef006
void rffe_init(void)
{
uint16_t reg;
reg = readw(ARM_CONF_REG);
reg &= ~ (1 << 7); /* TSPACT4 I/O function, not nRDYMEM */
writew(reg, ARM_CONF_REG);
reg = readw(MCU_SW_TRACE);
reg &= ~(1 << 1); /* TSPACT9 I/O function, not MAS(1) */
writew(reg, MCU_SW_TRACE);
/* Configure the TSPEN which is connected to the TWL3025 */
tsp_setup(IOTA_STROBE, 1, 0, 0);
trf6151_init(RITA_STROBE, RITA_RESET);
}
uint8_t rffe_get_gain(void)
{
return trf6151_get_gain();
}
void rffe_set_gain(uint8_t dbm)
{
trf6151_set_gain(dbm);
}
const uint8_t system_inherent_gain = SYSTEM_INHERENT_GAIN;
/* Given the expected input level of exp_inp dBm/8 and the target of target_bb
* dBm8, configure the RF Frontend with the respective gain */
void rffe_compute_gain(int16_t exp_inp, int16_t target_bb)
{
trf6151_compute_gain(exp_inp, target_bb);
}
void rffe_rx_win_ctrl(int16_t exp_inp, int16_t target_bb)
{
/* FIXME */
}
|
