1 files changed, 0 insertions, 80 deletions
diff --git a/src/target/firmware/board/common/rffe_compal_dualband.c b/src/target/firmware/board/common/rffe_compal_dualband.c
deleted file mode 100644
index bfd3d98e..00000000
--- a/src/target/firmware/board/common/rffe_compal_dualband.c
+++ /dev/null
@@ -1,80 +0,0 @@
-#include <stdint.h>
-#include <stdio.h>
-
-#include <debug.h>
-#include <memory.h>
-#include <rffe.h>
-#include <calypso/tsp.h>
-#include <rf/trf6151.h>
-
-/* This is a value that has been measured on the C123 by Harald: 71dBm,
-   it is the difference between the input level at the antenna and what
-   the DSP reports, subtracted by the total gain of the TRF6151 */
-#define SYSTEM_INHERENT_GAIN	71
-
-/* describe how the RF frontend is wired on the Motorola E88 board (C117/C118/C121/C123) */
-
-#define		RITA_RESET	TSPACT(0)	/* Reset of the Rita TRF6151 */
-#define		PA_ENABLE	TSPACT(1)	/* Enable the Power Amplifier */
-#define		TRENA		TSPACT(6)	/* Transmit Enable (Antenna Switch) */
-#define		GSM_TXEN	TSPACT(8)	/* GSM (as opposed to DCS) Transmit */
-
-#define		IOTA_STROBE	TSPEN0		/* Strobe for the Iota TSP */
-#define 	RITA_STROBE	TSPEN2		/* Strobe for the Rita TSP */
-
-/* switch RF Frontend Mode */
-void rffe_mode(enum gsm_band band, int tx)
-{
-	uint16_t tspact = tsp_act_state();
-
-	/* First we mask off all bits from the state cache */
-	tspact &= ~PA_ENABLE;
-	tspact |= TRENA | GSM_TXEN;	/* low-active */
-
-#ifdef CONFIG_TX_ENABLE
-	/* Then we selectively set the bits on, if required */
-	if (tx) {
-		tspact &= ~TRENA;
-		if (band == GSM_BAND_900)
-			tspact &= ~GSM_TXEN;
-		tspact |= PA_ENABLE;	/* Dieter: TODO */
-	}
-#endif /* TRANSMIT_SUPPORT */
-
-	tsp_act_update(tspact);
-}
-
-#define MCU_SW_TRACE	0xfffef00e
-#define ARM_CONF_REG	0xfffef006
-
-void rffe_init(void)
-{
-	uint16_t reg;
-
-	reg = readw(ARM_CONF_REG);
-	reg &= ~ (1 << 5);	/* TSPACT6 I/O function, not nCS6 */
-	writew(reg, ARM_CONF_REG);
-
-	reg = readw(MCU_SW_TRACE);
-	reg &= ~(1 << 5);	/* TSPACT8 I/O function, not nMREQ */
-	writew(reg, MCU_SW_TRACE);
-}
-
-uint8_t rffe_get_gain(void)
-{
-	return trf6151_get_gain();
-}
-
-const uint8_t system_inherent_gain = SYSTEM_INHERENT_GAIN;
-
-/* Given the expected input level of exp_inp dBm/8 and the target of target_bb
- * dBm8, configure the RF Frontend with the respective gain */
-void rffe_set_gain(int16_t exp_inp, int16_t target_bb)
-{
-	trf6151_compute_gain(exp_inp, target_bb);
-}
-
-void rffe_rx_win_ctrl(int16_t exp_inp, int16_t target_bb)
-{
-	/* FIXME */
-}