aboutsummaryrefslogtreecommitdiffstats
path: root/Transceiver52M/radioInterfaceDiversity.cpp
AgeCommit message (Collapse)AuthorFilesLines
2014-10-06Transceiver52M: Add SCH detection capabilityThomas Tsou1-1/+1
Use similar approach for detecting normal and RACH bursts, but apply a sample shift after detection in order to gradually zero the measured timing offset. SCH synchronization sequence and setup are added similar to RACH detection with the main difference, aside being the SCH runs full length of the burst. History is also added to accommodate full length burst correlation. Signed-off-by: Thomas Tsou <tom@tsou.cc>
2013-11-15Transceiver52M: Add dual channel diversity receiver optionThomas Tsou1-0/+248
This patch add support for dual channel diversity on the receive path. This allows two antennas two shared antennas to be used for each ARFCN handling channel in the receiver. This configuration may improvde performance in multi-path fading environments, however, noise andpotential interference levels are increased due to the higher bandwidth used. The receive path is oversampled by a factor of four for a rate of 1.083333 Msps. If the receive paths are tuned within a maximum channel spacing (currently set at 600 kHz), then both ARFCN frequencies are processed by each channel of the receiver. Otherwise, the frequency shifted diversity path is disabled and standard non-diversity operation takes place. Diversity processing is handled by selecting the path with the higheset energy level and discarding the burst on the second path. Selection occurs on a burst-by-burst basis. Signed-off-by: Thomas Tsou <tom@tsou.cc>