! osmo-bsc configuration example for custom SCCP addresses ! e1_input e1_line 0 driver ipa network network country code 1 mobile network code 1 encryption a5 0 neci 1 paging any use tch 0 handover 0 handover algorithm 1 handover1 window rxlev averaging 10 handover1 window rxqual averaging 1 handover1 window rxlev neighbor averaging 10 handover1 power budget interval 6 handover1 power budget hysteresis 3 handover1 maximum distance 9999 dyn_ts_allow_tch_f 0 periodic location update 30 bts 0 type sysmobts band DCS1800 cell_identity 0 location_area_code 1 base_station_id_code 63 ms max power 15 cell reselection hysteresis 4 rxlev access min 0 radio-link-timeout 32 channel allocator ascending rach tx integer 9 rach max transmission 7 channel-descrption attach 1 channel-descrption bs-pa-mfrms 5 channel-descrption bs-ag-blks-res 1 early-classmark-sending forbidden ip.access unit_id 0 0 oml ip.access stream_id 255 line 0 neighbor-list mode manual-si5 neighbor-list add arfcn 100 neighbor-list add arfcn 200 si5 neighbor-list add arfcn 10 si5 neighbor-list add arfcn 20 codec-support fr gprs mode none no force-combined-si trx 0 rf_locked 0 arfcn 871 nominal power 23 ! to use full TRX power, set max_power_red 0 max_power_red 20 rsl e1 tei 0 timeslot 0 phys_chan_config CCCH+SDCCH4 hopping enabled 0 timeslot 1 phys_chan_config TCH/F hopping enabled 0 timeslot 2 phys_chan_config TCH/F hopping enabled 0 timeslot 3 phys_chan_config TCH/F hopping enabled 0 timeslot 4 phys_chan_config TCH/F hopping enabled 0 timeslot 5 phys_chan_config TCH/F hopping enabled 0 timeslot 6 phys_chan_config TCH/F hopping enabled 0 timeslot 7 phys_chan_config TCH/F hopping enabled 0 cs7 instance 0 point-code 0.42.1 !asp asp-clnt-OsmoBSC 2905 0 m3ua ! remote-ip 10.23.24.1 ! where to reach the STP sccp-address msc_remote point-code 0.23.1 msc 0 msc-addr msc_remote