aboutsummaryrefslogtreecommitdiffstats
path: root/tests/gb/gprs_ns_test.c
AgeCommit message (Collapse)AuthorFilesLines
2015-12-17ns: Force a defined state when sending NS RESETJacob Erlbeck1-0/+18
Currently the state is assumed to remain the same while the reset procedure is active. While this works correctly in general, a single unexpected BLOCK_ACK or UNBLOCK_ACK can change the state but will not stop the reset procedure. The leads to repeated RESET messages, where the corresponding RESET_ACK is ignored. This is a stable state which can only be left by manual intervention or by reception of a RESET message from the peer. This commit changes the RESET timeout handler to set the state to BLOCKED/RESET when sending the new NS RESET message. Note that this should ensure a clean restart even if the state has been screwed up. It does not fix the handling of BLOCK_ACK or UNBLOCK_ACK in abnormal cases. Addresses: gprs_ns.c:349 NSEI=8895 Tx NS RESET (NSVCI=8895, cause=O&M intervention) gprs_ns.c:878 NSVCI=8895 Rx NS RESET ACK (NSEI=8895, NSVCI=8895) gprs_ns.c:887 NS RESET ACK Discarding unexpected message for NS-VCI 8895 from SGSN NSEI=8895 Ticket: OW#1551 Sponsored-by: On-Waves ehf
2014-10-09gprs-ns/test: Check the nsvc state explicitelyJacob Erlbeck1-0/+7
This patch extends test_sgsn_reset_invalid_state by assertions to check that nscv->state and nsvc->remote_state have been set as expected. Sponsored-by: On-Waves ehf
2014-10-09gprs-ns/test: Re-add return value check for gprs_nsvc_resetHolger Hans Peter Freyther1-1/+3
The return value check has been removed in the commit 'Use gprs_nsvc_reset instead of gprs_ns_tx_reset', because gprs_nsvc_reset had no return value then. Since a compatible return value has been added by 'Let gprs_nsvc_reset return a value', the former patch is partly reverted by this commit. The printf is now an OSMO_ASSERT. The commit message was taken from Jacob. Sponsored-by: On-Waves ehf
2014-10-09gprs-ns: Fix reset state handlingJacob Erlbeck1-2/+0
Currently the NS-VC's state is updated from within gprs_ns_tx_reset, which can lead to an inconsistent state when the RESET_ACK is lost. In this state, the NSE_S_RESET bit is set but the Tns-reset timer is not started. This patch moves the state update into gprs_nsvc_reset. This way, the state flags are consistent with the timer. Addresses: SGSN -> BSS NS_ALIVE BSS -> SGSN NS_ALIVE_ACK BSS -> SGSN BVC_RESET SGSN -> BSS NS_STATUS, Cause: NS-VC blocked, NS VCI: 0x65 and there is no BSS->SGSN NS_ALIVE Ticket: OW#1213 Sponsored-by: On-Waves ehf
2014-10-09gprs-ns/test: Add test_sgsn_reset_invalid_stateJacob Erlbeck1-0/+64
This tests the behaviour for a certain combination of messages and packet losses that can put the NS-VC object into an undefined state. In that state, the peer's ALIVE messages are properly answered, but the local test procedure has stopped, incoming unitdata PDUs are answered by STATUS(NS-VC blocked) and the unblocking procedure is not initiated. Ticket: OW#1312 Sponsored-by: On-Waves ehf
2014-10-09gprs-ns/test: Add expire_nsvc_timerJacob Erlbeck1-0/+15
This function forces the expiration of the timer within struct gprs_nsvc. It is meant to be used for controlled (and faster) timer expiration in unit tests. The timer_mode of the expired timer is returned (or -1 if the timer wasn't active). Sponsored-by: On-Waves ehf
2014-10-09gprs-ns/test: Save the last PDU type sentJacob Erlbeck1-0/+4
This records the PDU type of the last message sent to the remote peer in the global variable sent_pdu_type, which can then be used in assertions. Note that sent_pdu_type will remain unchanged if no message has been sent via sendto. Sponsored-by: On-Waves ehf
2014-10-09gprs-ns/test: Use gprs_nsvc_reset instead of gprs_ns_tx_resetJacob Erlbeck1-15/+8
Currently gprs_ns_tx_reset is used to let the NS stack generate NS_RESET message. This is not adjusting the nsvc state properly. This patch uses gprs_nsvc_reset instead which starts the full reset procedure. Sponsored-by: On-Waves ehf
2013-10-30grps: Add test for NS messages that shall be ignoredJacob Erlbeck1-0/+28
Several messages shall not be answered when a RESET hasn't been received on a NS-VC: - NS_RESET_ACK (see 3GPP TS 08.16, 7.3.1) - NS_ALIVE_ACK (see 3GPP TS 08.16, 7.4.1) - NS_STATUS (see 3GPP TS 08.16, 7.5.1) Sponsored-by: On-Waves ehf
2013-10-24gb: Create new NSVC object instead of patching the NSVCIJacob Erlbeck1-2/+3
When a RESET is received on the same link with a different NSVCI from a BSS on a dynamically created NS connection do not patch the nsvc object but create a new one instead. Thus the NSVCI is never modified at a nsvc object after the NS-VC has been established. Sponsored-by: On-Waves ehf
2013-10-24gb: Fix NS RESET/RESET_ACK abnormal casesJacob Erlbeck1-0/+6
This changes the implementations for the reception of RESET and RESET_ACK to be compatible with 3GPP TS 08.16, 7.3.1: - Just send a RESET_ACK with correct values back to the SGSN when a RESET with an invalid NSVCI or NSEI has been received. - Check RESET_ACK for matching NSEI and NSVCI. - Ignore unexpected RESET_ACKs. In addition, use RESET_ACK from a BSS to update the BSS source address based on the NSVCI to be tolerant with changing UDP source addresses/ports. Sponsored-by: On-Waves ehf
2013-10-24gb: Add test cases for NS RESET proceduresJacob Erlbeck1-0/+218
Add a test handling proper and mismatching RESETs. The latter may occur, when ports change within a NS-VC without the SGSN getting notice. This tests for the behavior of the NS protocol stack for RESET and RESET_ACK messages which changing/invalid NSEI and NSVCI like it is being described in 3GPP TS 08.16, 7.3.1. Sponsored-by: On-Waves ehf
2013-10-24gb: Fix gprs_nsvc_delete() to free ctr groupJacob Erlbeck1-0/+41
This fixes a SEGV error that happens the next time the statistics are updated. Addresses: Program terminated with signal 11, Segmentation fault. #0 0xb7711fa5 in rate_ctr_group_intv (grp=<optimized out>) at rate_ctr.c:107 107 for (i = 0; i < grp->desc->num_ctr; i++) { #0 0xb7711fa5 in rate_ctr_group_intv (grp=<optimized out>) at rate_ctr.c:107 #1 rate_ctr_timer_cb (data=0x0) at rate_ctr.c:129 #2 0xb770ec59 in osmo_timers_update () at timer.c:243 #3 0xb770ef7a in osmo_select_main (polling=0) at select.c:133 #4 0x08049987 in main (argc=3, argv=0xbfba8084) at gb_proxy_main.c:306 Sponsored-by: On-Waves ehf
2013-10-17gb: Test sending messages to the SGSNJacob Erlbeck1-27/+285
This adds tests for the gprs_ns_sendmsg() function. For this it merges back functions from the gbproxy test. Sponsored-by: On-Waves ehf
2013-10-15gb: Fix gprs_ns_rx_reset to not create NS-VC duplicatesJacob Erlbeck1-1/+27
Under special circumstances (see below) receiving a NS-RESET leads to duplicated NS-VC entries. This happens when the source port of a NS-VC changes to a new one that has already been used by another NS-VC. This patch changes gprs_ns_rx_reset() to check for this case and to use the existing NS-VC object. The NS-VC object that was associated with the source address before is detached from this source but kept in the NS-VC list so that it can be reattached when a correspondent NS-RESET is received later on. Meanwhile it will have a cleared link layer address which will not match a real link info. A new counter NS_CTR_REPLACED is incremented each time when the NS-VC object is replacing another one. A new signal S_NS_REPLACED is added which gets dispatched in this case, too. Another new counter NS_CTR_NSEI_CHG is incremented each time when the NSEI of a NS-VC object (with fixed NSVCI) changes. Ticket: OW#874 Sponsored-by: On-Waves ehf
2013-10-15gb: Add functions to access the LL part of the NS-VC objectsJacob Erlbeck1-5/+5
Adds the functions gprs_ns_ll_copy() and gprs_ns_ll_clear(). Renames gprs_ns_format_peer() to gprs_ns_ll_str(). All of these functions uniformly access the link layer part within the NS-VC objects. Sponsored-by: On-Waves ehf
2013-10-11tests/gb: Show invoked signals in test outputJacob Erlbeck1-1/+46
Register an osmo signal handler to print a short notice about every SS_L_NS signal that is generated while processing the tests. Sponsored-by: On-Waves ehf
2013-10-08tests/gb: Add test for GPRS NS protocolJacob Erlbeck1-0/+247
This tests the connection establishment by directly calling gprs_ns_rcvmsg() and printing the resulting messages and the NS-VC list.
generated by cgit v1.2.3 (git 2.25.1) at 2024-05-24 12:57:15 +0000